Power Switch - HP t820 Maintenance & Service Manual

Power switch

Description
Power switch
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the drive cage
5.
Disconnect the power switch cable from the system board connector labeled PB/LED.
6.
Remove the power switch cable from atop the front I/O bracket.
7. From the front of the computer, press down (or squeeze) on the top on the power switch (1), and
then rotate it down (2) to disengage it from the chassis.
8.
Pull the power switch and cable assembly out through the hole in the front of the chassis.
To install the power switch, reverse the removal procedure.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 19).
(Drive cage (fiber NIC assembly holder) on page
18).
Spare part number
732767-001
17).
34).
Power switch
43