The speaker is secured to the front of the chassis between the fan and the I/O ports. Remove the screws
from the outside and then remove the speaker from the inside.
Prepare the computer for disassembly
Remove the access panel
Remove the front bezel
Remove the front fan
Disconnect the speaker cable from the white system board connector labeled SPKR.
On the outside of the chassis, remove the two Torx T8 screws that secure the speaker to the
chassis (1), and then from the inside of the chassis, slide the speaker up to remove it (2).
To install the speaker, reverse the removal procedure.
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page
(Front fan on page
Spare part number