4. WARM-UP PROCEDURE
A) Check all fluids daily. (The unit is shipped without lubricating oil.)
B) Turn the fuel cock to ON position.
C) Set the main switch to OFF.
D) Pull out the Chock lever.
E) Turn the engine start key to START position.
F) Warm-up time is about 3-5 minutes.
- -
5. STARTING-UP PROCEDURE
A) Return speed control level to left position.
B) Ensure voltmeter indicates normal.
C) Set the main switch to ON.
D) Observe the voltage is in the normal loaded range.
6. STOP PROCEDURE
A). Set the main switch to OFF.
B). Turn the engine start key to STOP position.
C). Close the fuel cock if the unit is in storage or transportation.
- -