Preparatory Steps For Operation; Safety Precations For Servicing - Kipor KGE12E Operation Manual

2. PREPARATORY STEPS FOR OPERATION

1) Environmental Requirements
1-1) Outdoor use
A) Install your unit in a dry and dustless place.
B) Avoid the direct sunshine. Place your unit in shade.
C) Keep your unit on a lever ground so that the unit will not move by itself .
safely, Fix the unit on the ground by pegging.
1-2) Indoor use
A) Use in well-ventilated areas, or vent exhaust outside and away from any
building air intakes. A large volume of air is required for the operation.
B) Keep the air inlet /outlet and the exhaust gas outlet 1.5m away from any
obstacle.
C) Use under 40 degrees temperature.
D) Install your unit on a level surface.
2) Preparation for the engine
A) Check level of fuel gasoline, Lubrication oil. Add any of those fluids if is below
the sufficient level specified in the Engine Owner's Manual.
B) Check all major bolts and nuts on the engine. Tighten any loose bolts and nuts.
3) Electrical connection with load
A) Make sure that the load does not exceed the power capacity of your unit.
Connect electrical connections properly.
- -

3. SAFETY PRECATIONS FOR SERVICING

A). Only qualified persons should test, maintain., and repair this unit.
B). Always wear a face shield, rubber gloves and protective clothing
when working on the unit.
C). Do not touch the generator unit or any part of load with your bare
For
hands or wet hands
D). Keep hands, hair, loose clothing, and tools away from moving pars
such as fans, belts and rotors.
E). Do not breathe exhaust fumes.
D). Stop engine and let it cool off before checking or adding fuel.
G). Do not add fuel while smoking or unit is near any sparks or open
flames.
H). Observe correct polarity ( & ) on batteries.
I). Do not tip battery.
J). Use equipment of adequate capacity to lift and support unit and
components.
- -