Refill Salt Indicator - Miele PG 8080 U Operating Instructions Manual

Refill salt indicator

^ Refill the salt reservoir as soon as the
F
Add salt
message is displayed (if
it appears during a program, wait
until the end of the program).
^ Press the centre button to confirm.
The Refill salt indicator goes out.
If a sufficiently high concentration of
salt has not yet formed, Refill salt may
continue to be displayed after adding
the salt.
In this case, confirm again with the
centre button.
The Refill salt message is turned off if
you have programmed the commercial
dishwasher to a water hardness below
4 gr/gal (= 70 ppm CaCO3).
,
Immediately after each refill run
the Pre-wash or Short program
without a load in order to remove
any traces of brine from the cabinet.
Before using for the first time
23