Maintenance; Cleaning The Water Inlet Screen - Miele PG 8080 U Operating Instructions Manual

Cleaning the water inlet screen

There is a screen in the screw
connection of the water inlet hose to
protect the water inlet valve. The screen
must be cleaned when dirty, otherwise
insufficient water will flow into the wash
cabinet.
,
The plastic housing of the water
connection contains an electric
valve. The housing must not be
immersed in water.
Recommendation
If the water supply contains a large
amount of insoluble substances, we
recommend fitting a large-area filter
between the tap and the water inlet
hose.
This filter is available from Miele Ser-
vice.
To clean the screen:
^ Disconnect the commercial
dishwasher from the electric power
supply. Always switch the appliance
off before unplugging it.
^ Close the water tap.
^ Unscrew the water inlet valve.
^ Take the seal ring out of the screw
connection.
^ Use needlenose pliers to pull out the
screen, then clean it.
^ When removing the screen, take care
not to pull out or displace the flow
regulator behind it.
^ Replace the screen and seal. Make
sure they are positioned correctly.
^ Reconnect the water inlet valve to the
tap. Make sure not to cross-thread
the connection.
^ Turn the tap back on.
If the connection leaks it might be too
loose or cross-threaded.
Unscrew and reconnect the water
inlet valve correctly.

Maintenance

59