Table of Contents
Advertisement
Filling the salt reservoir
Before filling the salt reservoir for the
first time, you must fill it with approx.
2 litres of water to enable the salt to
dissolve.
Once the dishwasher has been used,
there is always sufficient water in the
reservoir.
Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.
Risk of corrosion due to saline
solution.
Water or saline solution will run out
of the reservoir when the cap is
removed. Saline solution that runs
out can cause corrosion in the wash
cabinet and to the dishwasher load.
The salt reservoir should therefore
only be opened in order to replenish
the salt.
Before using for the first time
Place the funnel provided over the
salt reservoir and carefully fill with
dishwasher salt until the reservoir is
full. The salt reservoir holds approx.
2 kg of salt, depending on the type of
salt used.
Clean any excess salt from around
the reservoir opening and then screw
the cap on again firmly.
Run the
immediately without a load in order to
remove any traces of salt from the
cabinet.
Salt refill indicator
When
Add salt
display wait until the end of the
programme and then refill the salt
reservoir.
Confirm with OK.
The salt refill indicator will go out.
Danger of corrosion!
Run the Cold pre-wash
programme immediately without any
load items in order to remove any
traces of salt from the cabinet.
Cold pre-wash
programme
appears in the
23
Advertisement
Table of Contents
