Replacing The Battery - Fujitsu Primergy BX630 S2 Options Manual

8

Replacing the battery

To allow permanent saving of the system information, a lithium battery is
installed which supplies the CMOS memory with power. If the battery charge is
too low or the battery is empty, a corresponding error message is displayed. In
this case, the lithium battery must be replaced.
V
CAUTION!
Observe the safety notes and the information on handling batteries in the
section "Batteries" on page
result in a risk of explosion. The batteries must be replaced with an
identical battery or with a battery type recommended by the manufac-
turer. Make sure you insert the battery correctly. The positive pole must
face toward the inside of the server blade.
Figure 25: Replacing the battery
Ê Press the locking lever in the direction of the arrow (1) and remove the
battery from its carrier (2).
Ê Insert a new lithium battery of identical type into the carrier (3) and engage
it with the lever (4).
BX630 S2
17. Incorrect replacement of batteries may
2
1
Options Guide
3
4
43