Fujitsu Primergy BX630 S2 Options Manual page 49

Upgrading to a quad-socket server blade
The quad-socket server blade is controlled via the control panel of the master
module. You must remove the control panel board of the slave module.
2
Figure 33: Removing the control panel board
Ê Undo the two screws (1) fastening the control panel board to the server
blade housing.
Ê Loosen the clamping bracket (2) and disconnect the cable of the control
panel board from the connector on the system board.
Figure 34: Removing the control panel board
Ê Remove the control panel board with the connection cable from the server
blade housing.
BX630 S2
Options Guide
Assembly instructions
1
49