Procedure - Fujitsu Primergy BX630 S2 Options Manual

2

Procedure

V
CAUTION!
The actions described in this manual should only be performed by
technical specialists.
Equipment repairs should only be performed by service staff.
Any failure to observe the guidelines in this manual, and any unautho-
rized opening or improper repairs could expose the user to risks
(electric shock, energy hazards, fire hazards) or damage the
equipment.
Please note that any unauthorized opening of the server will void the
warranty and exempt the manufacturer from all liability.
Ê First of all please familiarize yourself with the safety instructions in the
chapter "Safety instructions" on page
Ê Make sure that all the manuals you need are available and print out the PDF
files if necessary. You will definitely need the operating manuals of the server
blade and of your BX600 S2 or BX600 S3 basic unit.
Ê Shut down the server blade correctly, switch it off and remove it from the
basic unit as described in the Completion.
Ê Extend or upgrade your server blade as described in the relevant chapter.
I
The installation and removal of the hot-plug components is described
in the Operating Manual supplied with the server blade.
Ê Close the server blade, place it back in the basic unit and switch on the
server blade as described in
Ê Start the operating system and, if necessary, configure it as required (see
the Operating Manual).
BX630 S2
15.
chapter "Completion" on page
Options Guide
57.
13