H3C S9500E Series Configuration Manual page 53

Switch the operating mode of Device A from IRF to standalone.
3.
[IRF] undo chassis convert mode
The device will switch to stand-alone mode and reboot. You are recommended to save the
current running configuration and specify the configuration file for the next startup.
Continue? [Y/N]:y
Do you want to convert the content of the next startup configuration file flash:/vrpcfg.cfg
to make it available in stand-alone mode? [Y/N]:y
Please wait.............
Saving the converted configuration file to main board succeeded.
Chassis 1 Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device A automatically reboots to complete the operating mode switch.
Log in to Device B and switch the operating mode of Device B from IRF to standalone.
4.
<IRF> system-view
[IRF] undo chassis convert mode
The device will switch to stand-alone mode and reboot. You are recommended to save the
current running configuration and specify the configuration file for the next startup.
Continue? [Y/N]:y
Do you want to convert the content of the next startup configuration file flash:/vrpcfg.cfg
to make it available in stand-alone mode? [Y/N]:y
Please wait.............
Saving the converted configuration file to main board succeeded.
Chassis 2 Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device B automatically reboots to complete the operating mode switch.
NOTE:
If you have created VLAN interfaces and configured IP addresses for the interfaces on the IRF fabric, and
both Device A and Device B have member ports of this VLAN, IP address collision occurs after the
operating mode of Device A and Device B switches to standalone. To remove the collision, log in to one
device and modify the IP address of this VLAN.
Enhanced IRF mode configuration example (four switches
forming an IRF fabric)
Network requirements
As shown in
To increase access bandwidth, add three devices and configure them and Device A to form an IRF fabric,
as shown in
Figure 19, Device A cannot provide enough access bandwidth.
Figure 20.
45