H3C S9500E Series Configuration Manual page 50
Routing switches irf configuration guide
Hide thumbs
Also See for S9500E Series:
- Configuration manual (459 pages) ,
- Command reference manual (225 pages) ,
- Security configuration manual (207 pages)
Table of Contents
Advertisement
<Sysname> system-view
[Sysname] chassis convert mode irf
The device will switch to IRF mode and reboot. You are recommended to save the current
running configuration and specify the configuration file for the next startup. Continue?
[Y/N]:y
Do
you
want
to
flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
Please wait...
Saving the converted configuration file to the main board succeeded.
Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device A operates in IRF mode after reboot.
Configure Device B
2.
# Set the member ID of Device B to 2, create IRF port 1, and bind it to physical port Ten-GigabitEthernet
3/0/1.
<Sysname> system-view
[Sysname] irf member 2
Info: Member ID change will take effect after the switch reboots and operates in IRF mode.
[Sysname] irf-port 1
[Sysname-irf-port1] port group interface ten-gigabitethernet 3/0/1
[Sysname-irf-port1] quit
# Save the running configuration to the configuration file for next startup.
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/cfa0516.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/cfa0516.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait.....................................
The current configuration is saved to the active main board successfully.
Configuration is saved to device successfully.
# Connect the two devices as shown in
# Switch the operating mode of Device B to IRF.
<Sysname> system-view
[Sysname] chassis convert mode irf
The device will switch to IRF mode and reboot. You are recommended to save the current
running configuration and specify the configuration file for the next startup. Continue?
[Y/N]:y
Do
you
want
to
flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
Please wait...
Saving the converted configuration file to the main board succeeded.
Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device B and Device A form an IRF after Device B reboots.
Configure the IRF fabric
3.
convert
the
content
Figure
convert
the
content
42
of
the
next
17.
of
the
next
startup
configuration
startup
configuration
file
file
Advertisement
Table of Contents
