Arp Mad Detection-Enabled Irf Configuration Example (Pre-Configuration Mode) - H3C S9500E Series Configuration Manual
Routing switches irf configuration guide
Hide thumbs
Also See for S9500E Series:
- Configuration manual (459 pages) ,
- Command reference manual (225 pages) ,
- Security configuration manual (207 pages)
Table of Contents
Advertisement
The current configuration is saved to the active main board successfully.
Configuration is saved to device successfully.
# Connect the two devices as shown in
# Switch the operating mode of Device B to IRF.
<Sysname> system-view
[Sysname] chassis convert mode irf
The device will switch to IRF mode and reboot. You are recommended to save the current
running configuration and specify the configuration file for the next startup. Continue?
[Y/N]:y
Do
you
flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
Please wait...
Saving the converted configuration file to the main board succeeded.
Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device B and Device A form an IRF fabric when Device B reboots.
Configure BFD MAD
3.
# Create VLAN 3, and add port GigabitEthernet 1/4/0/1 (located on Device A) and port
GigabitEthernet 2/4/0/1 (located on Device B) to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] port gigabitethernet 1/4/0/1 gigabitethernet 2/4/0/1
[Sysname-vlan3] quit
# Create VLAN-interface 3 and configure a MAD IP address for the interface.
[Sysname] interface vlan-interface 3
[Sysname-Vlan-interface3] mad bfd enable
[Sysname-Vlan-interface3] mad ip address 192.168.2.1 24 member 1
[Sysname-Vlan-interface3] mad ip address 192.168.2.2 24 member 2
[Sysname-Vlan-interface3] quit
# Because BFD MAD detection and spanning tee function are mutually exclusive, disable the spanning
tree function on ports GigabitEthernet 1/4/0/1 and GigabitEthernet 2/4/0/1.
[Sysname] interface Gigabitethernet 1/4/0/1
[Sysname-Gigabitethernet1/4/0/1] undo stp enable
[Sysname-Gigabitethernet1/4/0/1] quit
[Sysname] interface Gigabitethernet 2/4/0/1
[Sysname-Gigabitethernet2/4/0/1] undo stp enable
ARP MAD detection-enabled IRF configuration example
(pre-configuration mode)
Network requirements
The network (see
Device A.
want
to
convert
Figure
17) is outgrowing the forwarding capability of the existing core switch, namely,
Figure
16.
the
content
of
the
40
next
startup
configuration
file
Advertisement
Table of Contents
