H3C S9500E Series Configuration Manual page 33

Figure 9 Network diagram
Configuring LACP MAD detection
3.
Configure LACP MAD detection by following these steps:
• Create an aggregate interface (also required on the intermediate device);
Configure the aggregation group to work in dynamic aggregation mode; (also required on the
•
intermediate device)
Enable LACP MAD detection on the dynamic aggregate interface;
•
Add member ports to the aggregation group.(also required on the intermediate device)
•
To configure LACP MAD detection:
To do...
Enter system view
Assign a domain ID to the IRF
fabric
Create an aggregate interface
Configure the aggregation group
to work in dynamic aggregation
mode
Use the command...
system-view
irf domain domain-id
interface bridge-aggregation
interface-number
link-aggregation mode dynamic
25
Remarks
—
Required
By default, the domain ID of an
IRF fabric is 0.
Required
Required
By default, the aggregation
group works in
aggregation mode.
static