Pre-Configuring An Irf Member Switch In Standalone Mode - H3C S9500E Series Configuration Manual

Modify the binding between an IRF port and physical IRF ports (such as deleting a binding or
•
adding a new binding), and the configuration of IRF ports may affect the operation of the switch
(for example, causing IRF partition, or IRF merge).
Complete these tasks to configure an IRF fabric in non pre-configuration mode:
Task
Setting a member ID for the switch
Enabling enhanced IRF mode
Saving the running configuration to the configuration file to be used
at the next system startup
Switching operating mode
Accessing
fabric
Configuring
member switches in
IRF mode
Pre-configuring an IRF member switch in standalone
mode
You can configure the IRF ports, member ID, and member priority for the switch when it is operating in
standalone mode. Configurations take effect when the operating mode of the switch switches to IRF.
Accessing the active MPU of an IRF fabric
an IRF
Accessing a standby MPU of an IRF fabric
Configuring IRF ports
Setting a member ID for the switch
Specifying a priority for a member switch
Physically connecting
operating in standalone mode
Configuring a description for a member
IRF
switch
Specifying the preservation time of the
bridge MAC address
Enabling auto reboot for IRF fabric merge
Enabling automatic boot file updating
Setting the IRF link down report delay
Enabling IRF link failure detection and
auto-recovery
Configuring MAD detection
Performing IRF configuration fast recovery
Remarks
Required
Optional
Perform this task to use three or four
switches to form an IRF fabric.
Required
Required
Required
Optional
Required
Optional
Optional
Required
Be sure to connect the switches
two switches
according
described in the section
requirements." Otherwise, they cannot
form an IRF fabric.
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
11
to the requirements
"Connecting