H3C S9500E Series Configuration Manual page 36

Figure 11 Network diagram (with an intermediate switch)
Configuring BFD MAD detection
3.
Configure BFD MAD detection in the following order:
Create a VLAN dedicated to BFD MAD detection. This is also required on an intermediate switch,
•
if it exists.
Select the physical IRF ports for BFD MAD detection (at least one on each member switch) and add
•
them into the detection-dedicated VLAN. This is also required on an intermediate switch, if it exists.
Create VLAN interfaces for the detection-dedicated VLAN, enable BFD MAD detection on these
•
interfaces, and then assign MAD IP addresses for them.
To configure BFD MAD:
To do...
Enter system view
Create a new VLAN dedicated to
BFD MAD detection
Return to system view
Enter Ethernet interface view
Access port
Assign the port
Use the command...
system-view
vlan vlan-id
quit
interface
interface-number
port access vlan vlan-id
28
Remarks
—
Required
The default VLAN on the switch
is VLAN 1.
—
interface-type
—
Required