Removing Engine/Transmission - Arctic Cat Prowler HDX Service Manual

Removing Engine/
Transmission
Many service procedures can be performed without
removing the engine/transmission from the frame.
Closely observe the note introducing each sub-section for
this important information.
AT THIS POINT

If the technician's objective is to service/replace right-
side cover oil seals, front output joint oil seal, rear out-
put joint oil seal, and/or the oil strainer (from beneath
the engine/transmission), the engine/transmission does
not have to be removed from the frame.
Support the vehicle on a suitable lift or jack stands allow-
ing room to perform work from the underside.
NOTE: Locate the jack stands to allow removing
of the center belly panel.
! WARNING
Make sure the vehicle is solidly supported on the sup-
port stands to avoid injury.
1. Remove the seat, seat back, and seat base; then
disconnect negative battery cable.
2. Remove the center skid plate; then drain the oil
and coolant.
3. Remove the center floorboard.
4. Marking all nylon tie locations for installing pur-
poses, from the right side disconnect the MAP
sensor connector (A), fuel injector connector (B),
ISC connector (C), and TPS connector (D).
5. Wrap the gasline hose connector with a shop cloth;
then remove the gasline hose connector from the
fuel rail.
! WARNING
Gasoline may be under pressure. Place an absorbant
towel around the connector to absorb any gasoline
spray when disconnected.
6. Loosen the clamp securing the air filter intake tube to
the air filter; then remove the mounting screw and
remove the intake tube.
7. Remove four sheet metal screws securing the air fil-
ter mounting bracket to the frame; then loosen the air
inlet boot clamp and disconnect the IAT sensor con-
nector and remove the air filter assembly.
HDX136A
HDX138A
HDX031A
HDX148A
HDX144A
37