Arctic Cat Prowler HDX Service Manual page 105

3. Remove the V-belt.
4. Remove the nut securing the fixed driven assembly; then
remove the assembly.
5. Remove the fixed drive face.
6. Remove the cap screws securing the clutch cover. Note
the location of the different-lengthed cap screws for
installing purposes. Using a rubber mallet, carefully
remove the cover. Account for two alignment pins.
102
CD963
Care must be taken when removing the cover so the
cover gasket is not damaged.
CD966A
 NOTE: For steps 7-12, refer to illustration CC829B.
 NOTE: To aid in installing, it is recommended that
the assemblies are kept together and IN ORDER.
PR388
KEY
A. Oil Pump Driven Gear
B. Oil Pump Drive Gear
C. Clutch Shoe Assembly
7. Remove the one-way clutch (D) from the clutch
housing. Note the location of the green alignment dot
(or the word OUTSIDE) for installing purposes.
8. Using a hydraulic press, remove the clutch housing
assembly from the clutch cover. Account for the left
fixed drive spacer and an O-ring inside the fixed
drive spacer.
CAUTION
D. One-Way Clutch
E. Final Drive Carrier Bearing
Housing
CD973A
CD974A
CC829B