Arctic Cat Prowler HDX Service Manual page 102

 NOTE: The sharp side of the snap ring should be
facing outward.
2. Install the water pump drive gear drive pin and the
drive gear (with the flat side of the gear facing out-
ward as noted in removing); then secure with the
snap ring.
 NOTE: The sharp side of the snap ring should be
facing outward.
 NOTE: Once the gears are secured, remove the oil
passage plug from the crankcase.
3. Install the two starter gear shafts; then install the two
starter gears (with the beveled side of the intermedi-
ate gear facing inward as noted in removing).
CD949
4. In order on the crankshaft, install a washer, ring gear,
key, and the magneto rotor. Secure with the nut.
Tighten to 107 ft-lb.
CD946A
CD944
5. Install the thrust washer and shift cam plate onto the
shift cam shaft; then coat the cap screw threads with
red Loctite #271 and tighten to 8 ft-lb.
CD139
PR447A
CD948A
CD940B
99