Arctic Cat Prowler HDX Service Manual page 19

6. Install one of the V-belt cover cap screws into the
driven pulley fixed face; then turn the cap screw
clockwise to spread the pulley faces. Remove the V-
belt.
INSTALLING
1. Place the V-belt into position on the driven pulley and
over the front shaft.
16
 NOTE: The arrows on the V-belt should point for-
ward.
2. Pinch the V-belt together near its center and slide the
spacer and movable drive face onto the driveshaft.
Secure the drive face with a washer and nut (coated with
red Loctite #271). Tighten the nut to 165 ft-lb
.
Make sure the movable drive face plate is fully engaged
onto the splines of the clutch shaft before tightening the nut
or false torque readings may occur. This will cause the
assembly to loosen damaging the shaft and clutch face
plate.
PR476A
NOTE: At this point, remove the cap screw from
the driven pulley face.
3. Rotate the V-belt and driven pulley/clutch until the V-
GZ085
belt is flush with the top of the driven pulley.
4. Place the V-belt cover gasket into position; then with the
dowel pins in position, install the cover and secure with
the cap screws making sure the different-lengthed cap
screws are in their proper location. Tighten the cap
screws to 8 ft-lb.
5. Install the storage compartment and secure with the
screws.
6. Install the gas tank (see Steering/Frame/Controls); then
install the floor (see Fuel/Lubrication/Cooling).
7. Install the seat, seat back, and seat base.
GZ085
CAUTION
GZ485A