Arctic Cat Prowler HDX Service Manual page 95

14. With the alignment pin installed in the camshaft, loosely
place the cam sprocket (with the recessed side facing the
cam shaft lobes) onto the camshaft. At this point, do not
"seat" the sprocket onto the shaft.
15. With the cam lobes directed down (toward the pis-
ton), maneuver the camshaft/sprocket assembly
through the chain and towards its seating position;
then loop the chain over the sprocket.
 NOTE: Note the position of the alignment marks on
the end of the camshaft. They must be parallel with
the valve cover mating surface. If rotating the cam-
shaft and sprocket is necessary for alignment, do not
allow the crankshaft to rotate and be sure the cam
lobes end up in the down position.
16. Seat the cam sprocket onto the camshaft making sure
the alignment pin in the camshaft aligns with the
smallest hole in the sprocket; then place the cam-
shaft/sprocket assembly onto the cylinder ensuring
the following.
92
A. Piston still at top-dead-center.
B. Camshaft lobes directed down (toward the pis-
ton).
C. Camshaft alignment marks parallel to the valve
cover mating surface.
D. Recessed side of the sprocket directed toward the
cam lobes.
E. Camshaft alignment pin and sprocket alignment
hole (smallest) are aligned.
If any of the above factors are not as stated, go back to
step 12 and carefully proceed.
17. Place the tab-washer onto the sprocket making sure it
covers the pin in the alignment hole.
732-307B
Care must be taken that the tab-washer is installed cor-
rectly to cover the alignment hole on the sprocket. If the
alignment pin falls out, severe engine damage will
result.
18. Install the first cap screw (threads coated with red
Loctite #271) securing the sprocket and tab-washer
to the camshaft. Tighten only until snug.
CD463
19. Rotate the crankshaft until the second cap screw
securing the sprocket to the camshaft can be
installed; then install the cap screw (threads coated
with red Loctite #271) and tighten to 10 ft-lb. Bend
the tab to secure the cap screw.
CF013A
CAUTION
CAUTION
ATV1027
CD464