Arctic Cat Prowler HDX Service Manual page 184

8. Using Spanner Wrench, tighten the bearing cap.
 NOTE: When tightening the bearing cap, note air
and excess oil being bled from the hole in the cap.
9. Install the bleed ball and set screw into the bearing
cap.
10. Charge the shock with nitrogen to 200 psi.
FS161
11. Using a 3/16-in. Allen-wrench, tighten the
nitrogen bladder.
FS150A
12. Install the air valve ball by gently tapping it with a
plastic mallet.
FS162
13. Test the shock for proper operation.
14. Using compressed air, blow all oil from the holes in
the bearing cap.
FS163
FS164
FS165
FS166
181