Arctic Cat Prowler HDX Service Manual page 70

8. Install the one-way clutch making sure that the green
dot or the word OUTSIDE is directed away from the
crankcase.
B. Clutch Cover
C. Fixed Drive Face
D. Movable Drive Face
NOTE: Steps 1-8 in the preceding sub-section
must precede this procedure.
9. Install two alignment pins and place the clutch cover
gasket into position. Install the clutch cover.
10. Tighten the clutch cover cap screws to 8 ft-lb.
11. Install the air intake plate. Apply red Loctite #271 to
the threads of the three Phillips-head cap screws;
then install and tighten securely.
12. Place the driven pulley assembly into position and
secure with the nut (threads coated with red Loctite
#271). Tighten to 147 ft-lb.
MD1286
MD1115
13. Slide the fixed drive face assembly onto the front
shaft.
14. Spread the faces of the driven pulley by threading a
V-belt cover cap screw into the fixed driven face and
tightening until the faces open sufficiently to allow
the V-belt to drop into the pulley approximately 3/4
in.
MD1117
MD1342
MD1068
KC134
67