Arctic Cat Prowler HDX Service Manual page 168

5. Remove the cap screw and lock nut securing the
knuckle to the upper A-arm. Discard the lock nut.
6. While holding the drive axle stationary, pull the top
of the knuckle out and down until it is free of the
drive axle.
7. Place a drain pan under the vehicle to contain any oil
leakage; then pushing the axle shaft in, pull the axle
assembly from the gear case.
PR221
REMOVING FRONT DRIVE AXLE
 NOTE: For removing a front drive axel, see Front
Differential in this section.
CLEANING AND INSPECTING AXLES
 NOTE: Always clean and inspect the drive axle com-
ponents to determine if any service or replacement is
necessary.
1. Using a clean towel, wipe away any oil or grease
from the axle components.
PR220A
2. Inspect boots for any tears, cracks, or deterioration.
 NOTE: If a boot is damaged in any way, it must be
replaced with a boot kit.
INSTALLING REAR DRIVE AXLE
PR218
1. Push the axle shaft into the CV coupler to release the lock
ring; then slide the drive axle into place in the gear case.
PR729C
CD019
PR729C
165