Placing A Waypoint - Raymarine hsb2 PLUS Series Owner's Handbook Manual

Chapter 5: Standard Chart Operations
• Erasing a Waypoint
• Moving a Waypoint
At the end is a section about using the ST60/80 Navigator Keypad to select,
edit, and name your waypoints.

Placing a Waypoint

The scenario Place and Goto a Waypoint on page 2-26 provides a simple
example of how to place a waypoint.
➤ To access the place waypoint soft keys, press MARKS :
PLACE WPT
PLACE WPT
MARKS
MARKS
AT CURSOR
AT CURSOR
➤ To place a waypoint at the cursor position or at the vessel position:
PLACE WPT
1. Press either the PLACE WPT AT CURSOR or the PLACE WPT AT VESSEL soft
AT CURSOR
key. The waypoint is added to the waypoint list and tagged using the next
available number.
PLACE WPT
AT VESSEL
The waypoint soft keys are displayed until you move the cursor away from
the waypoint or press CLEAR .
GOTO
WAYPOINT
You can use the EDIT WAYPOINT soft key to name the waypoint as
described in Editing Waypoints below.
2. Press CLEAR or ENTER to remove the place waypoint soft keys.
➤ To place a waypoint as latitude/longitude using the Waypoint List:
1. Press MARKS , followed by the WAYPOINT LIST soft key. The Waypoint List
MARKS
and associated soft keys are displayed.
WAYPOINT
2. Press the MAKE NEW WAYPOINT soft key followed by the LAT/LONG soft
LIST
key; the WPT POSITION (LAT/LONG) screen is displayed, with it's associated
soft keys. The waypoint is placed at the current vessel position, or if not
MAKE NEW
WAYPOINT
available, the cursor position.
PLACE WPT WAYPOINT
PLACE WPT WAYPOINT
AT VESSEL LIST
AT VESSEL LIST
EDIT ERASE
WAYPOINT WAYPOINT
LOAD/SAVE
USER CARD
D4169-1 D5572-1
MOVE
WAYPOINT
D4163-1
5-9