St80 System (Without Course Computer) - Raymarine hsb2 PLUS Series Owner's Handbook Manual

Appendix E: Connecting a Raymarine Heading Sensor

ST80 System (without Course Computer)

If you have a Raymarine ST80 system and a Raymarine active compass we
recommend that you configure your system as follows:
• Ensure the active compass is re-wired to provide heading data on NMEA.
• Provide 12V power to the active compass.
• Connect the active compass to NMEA input of the
• If you require heading data on the SeaTalk system when the
switched OFF, you must fit a NMEA/SeaTalk interface box (part number
Z290 or E85001). The NMEA heading data is connected to the interface
box (in addition to the
Set Bridge NMEA Heading OFF in the display System Set Up menu.
• If you do not fit a NMEA/SeaTalk interface box, set Bridge NMEA Head-
ing ON in the display System Set Up menu.
The
that when the display is switched OFF, heading data is not available on the
SeaTalk system.
• Manually calibrate the compass in NMEA mode as described in the section
Calibrating the ST80 Active Compass.
2
display).
hsb
2
display provides the heading data to the SeaTalk system. Note
hsb
E-5
2
hsb display.
2
display is
hsb