Changing The Targets Display - Raymarine hsb2 PLUS Series Owner's Handbook Manual

Chapter 3: Standard Radar Operations

Changing the Targets Display

The Pathfinder Plus Radar allows you to improve target visibility by changing
the following:
• Interference rejection
• Target expansion
• Target wakes
These parameters are accessed from the default soft key TARGETS .
This section explains how to change these modes and describes the effect of
each mode. The current settings are shown at the right-hand end of the status
bar as shown in Figure 3-9.
Status Bar
3nm
Figure 3-9:
➤ To change the settings of the target modes:
1. Press the TARGETS default soft key.
The target option soft keys are displayed, with the current selections high-
lighted.
TARGETS
2. Press the appropriate soft key to toggle the required setting between OFF
and ON .
Note: If an option is not available for the current setting, its soft key label is
grey. When you press the key, the system beeps and the setting remains OFF .
For the Wakes mode, press the WAKES soft key to step the highlighted
WAKES
OFF S M L
selection through the wake options.
You can use the soft keys to change the settings of any or all the modes on
this display.
3. When the required options are highlighted, press ENTER . The screen
returns to the default display with the new mode(s) in operation. The status
bar is updated to indicate which controls are switched on.
RINGS
126°T
1/2
Status Bar
INT REJ EXPANSION
OFF ON OFF ON
Wakes on Target Expansion on
TM TV3
AUTO WKS
H-UP
GST FTC
Interference Rejection on
WAKES
CLEAR
OFF S M L WAKES
D3642-2
3-11
EX GZ
RC IR
D3986-2