Page 1
Users are cautioned that maintenance and repairs should be performed by a Merrychef authorized service agent using genuine Merrychef replacement parts. Merrychef will have no obligation with respect to any product that has been improperly installed, adjusted, operated or not maintained in accordance with national and local codes or installation instructions provided with the product, or any product that has its serial number defaced, obliterated or removed, or which has been modified or repaired using unauthorized parts or by unauthorized service agents.
When using electrical appliances basic safety precau- IMPORTANT tions should be followed, including the following: This Merrychef oven will accomodate ½ size bun/sheet WARNING To reduce the risk of burns, electric shock, pans. Metal sheet pans may be used when placed on the...
ELECTRICAL INSTALLATION For all cord connected appliances: GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug.
PRECAUTIONS TO BE OBSERVED Read this manual before using your oven. As with all electrical appliances, it is wise to have the electrical connections inspected periodically. The oven interior and door seals should be cleaned frequently, following the instructions described in the CLEANING section. There is no need to switch off your oven after each function but remember to switch off at the end of the day or period of operation.
INSTALLATION Remove packing material and protective film from the oven. Included inside your oven are a metal coated pan to be used for catching crumbs, if required and a metal scoop to aid cleaning between the door and the oven cavity (see CLEANING). Note: Check for obvious signs of transit damage.
SUITABLE COOKING UTENSILS Manufacturer’s instructions should be checked to determine the suitability of individual containers or utensils using each of the cooking functions. IMPORTANT: only the Vitreous coated metal pan supplied with the oven or microwave safe containers can be used on the BOTTOM of the oven. DO NOT place metal trays or containers on the BOTTOM of the oven as arcing may occur.
Page 8
This is only one example of an infinite number of possible multi-stage programs that can be Note: Remember convection temperature takes time to change. Do not expect an instant response when a different temperature is activated. The instructions outlined in this guide are intended to ensure the safety and long life of your Merrychef oven.
At the first sign of wear they cooking. The metal grill covering the fan must be should be replaced by a Merrychef approved Service kept clean and free of debris (See CLEANING) Agent.
Page 10
The air is then heated and returned to the cavity over of damage. At the first sign of wear they should be the edges of the rear baffle to produce an even heat replaced by a Merrychef approved Service Agent. pattern in the oven. This layout minimises areas TEMPERATURE SENSOR where grease build up can occur.
CONTROL PANEL MenuKeY MULTI-STAGE INDICATOR SOCKET PROGRAM PAD TIME/ERROR DISPLAY POWER PADS CONVECTION PAD CANCEL PAD TEMPERATURE SETTING PADS TIME/PROGRAM SELECT PADS COLON TIME/ERROR DISPLAY POWER PADS CANCEL/ CALLBACK ‘C’ PAD There are 4 Microwave Power Pads to select from: Cancels all timed cooking cycles, pre-programmed op- 25%, 50%, 75%, and 100%.
OPERATING INSTRUCTIONS: MANUAL MODE The oven can be operated in manual WARNING: or programmed mode. It is important DO NOT APPLY MICROWAVE ENERGY WHEN OVEN IS EMPTY to understand manual mode prior to DO NOT USE THE OVEN WITHOUT attempting program operation. CLEAN AIR FILTERS IN POSITION To familiarize yourself with the controls place a bowl containing approximately 2.5 pints of water in the oven.
AUDIBLE WARNING At the end of every timed cycle an audible warning will sound. The audible warning stops when the door is opened. On closing the door after interrupting the cycle the audible warning sounds as a reminder to start the timer (see PAUSE FACILITY).
Page 14
PROGRAMMING NUMBER PADS ( 01-99 ) Pre-programming allows repetitive cooking procedures to be stored for ease of use. Each program can comprise up to three stages, allowing at each, independent Some experimentation control of Convection temperature, Stage time and Microwave power level. will be required to However, programs must be used with caution, since if the food to cook varies determine the correct...
Page 15
RUNNING A PROGRAM Using number pad keys to run a program Programs 01 to 99 can be recalled using the number pad keys. The following procedure should be used to activate these programs. Programs can be halted Pre-heat the oven to the required starting temperature by and cancelled at any time pressing a TEMPERATURE SETTING PAD.
MenuKey : CHANGING OVEN MENU PROGRAMS The MenuKey System automatically changes all the cooking programs with the turn of a key. To change the menus on the oven: Ensure the power switch is off. Lift the MenuKey cover in the front panel of the oven and put the key in the keyhole Turn the key clockwise to the...
CLEANING: 1 For the oven to operate at peak efficiency, the cavity, door and air filters must be kept clean. A daily cleaning routine will ensure that you comply with the required hygiene standards and will help to maintain and prolong the efficiency of your oven. Follow the SAFETY INSTRUCTIONS at the beginning of this manual.
Page 18
Merrychef 503 Apply non-caustic oven cleaner to interior surfaces except door Merrychef recommends the use of approved Merrychef seals. Leave for the recommended time. Wash off using a clean cloth Oven Cleaner and Merrychef and plenty of clean, warm water. Dry using a fresh, clean cloth.
PROBLEM SOLVING Error code display The Merrychef Oven will identify some of the most common problems by flashing an error message code in the time display window. Fault Recommended action Error code display Door not fully shut. Close door fully.
Need help?
Do you have a question about the 501 and is the answer not in the manual?
Questions and answers