MAINTENANCE WORK ON CHASSIS AND ENGINE
Greasing the steering head bearing
9.19
Dismounting the front fender
9.20
Installing the front fender
9.21
–
Tighten nut
Requirement
Nut, steering stem
–
Position the handlebar support.
–
Mount and tighten screws
Requirement
Screw, handlebar support
300742-10
–
Position the handlebar with the handlebar clamps.
–
Mount and tighten screws
–
Position the fuel tank breather
–
Install the front fender. (
–
Install the fork legs.
–
Check the cable harness, bowden cables and brake line for freedom of movement
and routing.
–
Check play of steering head bearing. (
300743-10
x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
400563-01
–
Remove screws
700479-10
–
Position the fender with holding lugs
plate.
700480-01
.
.
M10
.
.
p. 30)
(
p. 27)
x
p. 25)
(
p. 28)
x
(
p. 29)
x
. Remove the front fender.
into the drill holes on the start number
M20x1.5
30 Nm
(22.1 lbf ft)
Loctite
®
40 Nm
(29.5 lbf ft)
30
243™