Adjusting Chain Tension - After Checking; Adjusting Chain Tension - Installing Rear Wheel; Adjusting The Chain Guide - KTM 50 SX Owner's Manual
Ktm 50 sx series motorcycles owner's manual
Hide thumbs
Also See for 50 SX:
- Repair manual (159 pages) ,
- Owner's manual (91 pages) ,
- Setup instructions (19 pages)
Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting chain tension - after checking
9.34
Adjusting chain tension - installing rear wheel
9.35
Adjusting the chain guide
9.36
Info
The size of the chain wheel varies with the number of teeth. The chain guide can be adjusted on small sprockets.
–
Loosen nut
–
Adjust the chain tension by turning the adjusting screws
Requirement
Chain tension
Turn adjusting screws
is aligned with the front wheel.
–
Make sure that the chain adjuster supports
screws
700484-11
–
Tighten nut
Requirement
Nut, rear wheel spindle
–
Remove the motorcycle from the work stand. (
–
Loosen nut
–
Adjust the chain tension by turning the adjusting screws
Requirement
Chain tension
Turn adjusting screws
is aligned with the front wheel.
–
Make sure that the chain adjuster supports
screws
700484-10
–
Tighten nut
Requirement
Nut, rear wheel spindle
–
Adjust the chain tension by turning the adjusting screws
Requirement
Chain tension
Turn adjusting screws
is aligned with the front wheel.
700484-12
x
–
Loosen screw
–
Position the chain guide.
–
Tighten screw.
Requirement
Remaining screws, chassis
700485-01
.
equally on the left and right. Check that the rear wheel
.
.
.
equally on the left and right. Check that the rear wheel
.
.
equally on the left and right. Check that the rear wheel
.
left and right.
≥ 3 mm (≥ 0.12 in)
are fitted correctly on the adjusting
M12x1
40 Nm
(29.5 lbf ft)
p. 21)
left and right.
≥ 3 mm (≥ 0.12 in)
are fitted correctly on the adjusting
M12x1
40 Nm
(29.5 lbf ft)
left and right.
≥ 3 mm (≥ 0.12 in)
M6
10 Nm (7.4 lbf ft)
35
Advertisement
Table of Contents
