MAINTENANCE WORK ON CHASSIS AND ENGINE
Refilling coolant
x
9.68
Warning
Danger of poisoning Coolants are poisonous and a health hazard.
–
Avoid contact between coolants and skin, eyes and clothing. If fuel gets into your eyes, rinse immediately with water and
contact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor
immediately. Change clothes that have come into contact with coolants. Keep coolants out of the reach of children.
Removing main silencer
9.69
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
–
Stand the vehicle upright.
–
Place a suitable container under the engine.
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Requirement
Screw, water pump cover
300617-10
–
Make sure that the screw
–
Stand the vehicle upright.
–
Pour coolant in up to measurement
Requirement
10 mm (0.39 in)
Coolant
700511-01
–
Mount the radiator cap.
–
Make a short test ride.
–
Check the coolant level. (
–
Remove screw
–
Remove screw
700512-01
–
Pull the main silencer off of the manifold at the rubber sleeve
700513-10
. Remove the radiator cap.
with a new seal ring.
M6
is tightened.
above the radiator fins.
0.5 l (0.5 qt.)
Coolant (
Coolant (mixed ready to use) (
p. 48)
.
.
49
10 Nm (7.4 lbf ft)
p. 73)
p. 73)
.