Checking/Measuring Clutch; Dismantling Centrifugal Clutch; Assembling Centrifugal Clutch - KTM 50 SX Owner's Manual
Ktm 50 sx series motorcycles owner's manual
Hide thumbs
Also See for 50 SX:
- Repair manual (159 pages) ,
- Owner's manual (91 pages) ,
- Setup instructions (19 pages)
Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Checking/measuring clutch
9.92
Dismantling centrifugal clutch
9.93
Assembling centrifugal clutch
9.94
–
Position the footbrake pedal.
–
Mount and tighten nut
Requirement
Remaining nuts, chassis
–
Mount the spring
–
Check the gear oil level. (
–
Check the clutch engagement speed.
300654-11
x
Condition
Centrifugal clutch removed.
–
Measure clutch.
Requirement
Clutch lining height
»
if the specified value is not met:
–
Replace the clutch linings.
–
Dismantle the centrifugal clutch.
–
Check clutch linings for damage.
»
If the clutch linings are damaged:
300610-10
–
Replace the clutch linings.
–
Assemble the centrifugal clutch.
x
Condition
Centrifugal clutch removed.
–
Loosen the screws
Mortise key (45229021000)
300513-10
–
Remove the screw
Info
The washer
not have to be removed.
–
Take off the clutch lining
–
Repeat the work on the other clutch linings.
300514-10
x
Condition
Centrifugal clutch removed.
.
M8
.
p. 55)
(
p. 57)
x
≥ 98.00 mm (≥ 3.8583 in)
(
p. 59)
x
x
(
p. 59)
using the special tool.
with the spacer
and spring
is used for adjusting the clutch engagement speed and does
.
30 Nm
(22.1 lbf ft)
.
59
Advertisement
Table of Contents
