MAINTENANCE WORK ON CHASSIS AND ENGINE
Filling up with gear oil
x
9.86
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
Adding gear oil
x
9.87
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
–
Place a suitable container under the engine.
–
Remove the gear oil drain plug with magnet
–
Completely drain the gear oil.
–
Thoroughly clean gear oil drain plug with magnet
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet
Requirement
Oil drain plug with magnet
700515-01
–
Remove the screw cap
Gear oil
–
Mount and tighten screw cap
Danger
Danger of poisoning Exhaust gases are poisonous and can result in uncon-
sciousness and/or death.
–
When running the engine, always make sure there is sufficient venti-
700516-01
lation, and do not start or run the engine in a closed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
–
Check the gear oil level. (
–
Remove gear oil level check screw
700525-01
–
Remove screw cap
–
Add gear oil until it flows out of the bore of the gear oil level screw.
Gear oil (ATF Dexron 3) (
–
Mount and tighten the gear oil level check screw.
Requirement
Screw, gear oil level check
–
Mount and tighten screw cap
300660-11
.
and the seal ring and tighten it.
M12x1.5
and fill up with gear oil.
0.20 l (0.21 qt.)
Gear oil (ATF Dexron 3) (
.
p. 55)
.
. Stand the vehicle upright.
p. 73)
M6
.
.
20 Nm
(14.8 lbf ft)
p. 73)
10 Nm (7.4 lbf ft)
56