Cleaning The Card Feed Rollers And Heat Rollers - Magicard Prima 2e Instruction Manual

Care and Cleaning
4.
Remove dirt on the fan filter using a vacuum
cleaner or other cleaning equipment.
Hold the sponge with your hand so that it is not sucked
into the cleaner.
If the sponge is removed, attach it again as shown
below.
Side filter
Press down the sponge into
the dents at four corners, and
set it under the tabs on the
frame.
Replace the fan filter when it begins to deteriorate.(the elasticity
of the sponge is lost and the sponge tends to be broken into
pieces.) It is recommended that fan filter should be replaced
once a year. Contact your dealer for details of replacing the filter.
5.
Install the fan filters back to the original positions.
38
(continued)
Dirty rollers are the major cause of jamming of the
cards. It is recommended to clean the rollers once after
printing about 1,000 cards. It is also recommended to
carry out cleaning before the work, because the
retransfer roller (heat roller) does not operate while it is
hot.
1.
2.
The printer initializes, and the [No Cassette] error is
indicated.
3.
Bottom filter
Place the sponge
under the tabs on the
frame.
4.
Insert the cleaning card in about 10 seconds. If you fails
to set the card within this time, the printer returns to
"Start OK?" Press the ENTER button again to proceed.
Cleaning the card feed rollers and heat
rollers
Remove the retransfer film cassette.
See p.17 in this manual.
Turn on the power of the printer.
From user mode select cleaning mode.
> U s e r M o d e
MENU
> C l e a n i n g >
Press the ENTER button. Select [Rollers] with ↑
and ↓ buttons, and press the ENTER button.
See p.30 in this manual.
> > R o l l e r s
ENTER
C l e a n i n g . .
S t a r t O K ?
ENTER
C l e a n i n g . .
O K ?