Set-Up; Connecting The Ic Unit (Sold Separately); Large Size Ic Unit (Sold Separately) - Magicard Prima 2e Instruction Manual

Set-up

Connecting the IC unit
(sold separately)
Large and compact size IC units are sold separately, as
are specialized optional devices for the printer. Consult
your dealer for more details.
WARNING
• Make sure that the power switch is turned
OFF and the AC cable is detatched from
the plug, before connecting and
disconnecting the IC units. Otherwise
Electric
electric shocks, fires or malfunction of the
shock
product may occur.
• Using IC units other than those specified
may cause electric shocks, fires or
malfunction of the product.

Large size IC unit (sold separately)

1.
A joint plate for an IC unit is provided as an
accessory.
2.
Fit the printer and IC unit into the holes as shown.
CX21ICL*
CX21ICL* is manufactured by us.
CAUTION
Unstable locations and angled
surfaces may cause card feeder malfunctions. Make sure
to fit the devices into the holes securely.
Furthermore, install the printer on a flat and hard surface.
3.
Connect the printer and IC unit.
Connect the cable which comes with the IC unit to the
OPTION 1 terminal.
Connecting to
the PRT interface
terminal
Connection cable
(Accessory)
CAUTION
Turn the power off before
connecting the cable between the printer and IC Unit.
Otherwise some malfunction may be caused.
4.
Connect the IC unit with the host computer.
Connect interface cables which are commercially
available.
The terminal is rotated 180°
Commercial item
Terminals on the rear of the IC unit
CAUTION
Make sure to tighten the screws of the interface cables.
Use the OPTION 1 side.
If you use side 2 it does not
function.
SERIAL1:non-contact
SERIAL2:contact
11