Operation; Turning On The Power - Magicard Prima 2e Instruction Manual

Operation

Turning on the power

1.
Before turning on the power, check the following:
Make sure that the printer door is completely
closed.
Make sure that the card tray is completely closed.
Make sure that the host computer is correctly
connected.
Make sure that any peripheral equipment is
correctly connected.
Make sure that the power supply outlet is correctly
connected.
(Power on the laminator first, if connected.)
Only switch the unit on after checking the above
points.
2.
Turn the power ON.
(I represents ON and O represents OFF.)
3.
The unit will be in the ready status approximately 4
minutes after turning on the power.
The operation display LED (READY LED) will light up.
READY
RESET
ERROR
EXIT
CAUTION
Do not turn the power off while the
LCD panel displays 'Boot up' to 'Initializing', as this
may cause malfunctions.
Making settings in the user modes
When the LCD panel displays Ready or Preheating,
R e a d y
press
For details concerning each user mode setting, see p. 27 of
this manual.
4.
The operation display LED (READY LED) will flash while the
unit is receiving image data from the host computer.
Be sure NOT to do any of the following during printing
operations and initialization process :
• Do not open the printer door.
• Do not open the card tray.
(while the LCD panel displays 'Loading')
• Do not turn off the power supply.
• Do not unplug the unit.
• Do not pull out the connection cable.
Failure to observe the above points will cause printing
to be aborted and may result in a malfunction of the
MENU
unit.
ENTER
P r e h e a t i n g . .
OR
MENU
button.
Enter the control command from the host computer to
print cards.
READY
RESET
ERROR
EXIT
MENU
ENTER
25