Table of Contents
Advertisement
Quick Links
Washer-Extractors
Twin Tub
UM202
Design 3 Models
Original Instructions
Keep These Instructions for Future Reference.
CAR4C_SVG
CAUTION: Read the instructions before using the machine.
(If this machine changes ownership, this manual must accompany machine.)
F8221501ENR4
www.alliancelaundry.com
October 2018
Advertisement
Table of Contents
Related Manuals for ALLIANCE UM202 series
Summary of Contents for ALLIANCE UM202 series
- Page 1 Washer-Extractors Twin Tub UM202 Design 3 Models Original Instructions Keep These Instructions for Future Reference. CAR4C_SVG CAUTION: Read the instructions before using the machine. (If this machine changes ownership, this manual must accompany machine.) F8221501ENR4 www.alliancelaundry.com October 2018...
-
Page 3: Table Of Contents
Maintenance..................26 Maintenance....................26 © Copyright 2018, Alliance Laundry Systems LLC All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. - Page 4 Daily......................26 Weekly......................26 Monthly....................... 26 Care of Stainless Steel................... 26 Disposal of Unit..................28 © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
-
Page 5: Introduction
Information in this manual is applicable to this model: If literature or replacement parts are required, contact the source from which the machine was purchased or contact Alliance Laun- UM202* dry Systems at +1 (920) 748-3950 for the name and address of the nearest authorized parts distributor. - Page 6 R i p o n , W I 5 4 9 7 1 U . S . A . CIRCUIT BREAKER SIZE: amps 24 lbs 11 kg MAX LOAD: SCHEM ATIC: 30 – 85 2 – 5.7 SUP PLY WATER: psi, CAR18N_SVG Figure 2 © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
-
Page 7: Safety Information
• Install the washer according the INSTALLATION instruc- warnings or precautions. To reduce the risk of poisoning or tions. Refer to the EARTH/GROUND instructions in the IN- © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... -
Page 8: Safety Decals
Any problems or conditions not understood should be reported to 1. Verify that all warning signs are present and legible. Replace the dealer, distributor, service agent or the manufacturer. as necessary. © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... - Page 9 Excessively high water level is evident. c. Machine is not connected to a properly grounded circuit. Do not bypass any safety devices in the machine. © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
-
Page 10: Specifications And Dimensions
14 [53] agitation cycle, gallons [liters] Medium 17 [64] High 21 [80] Drain Information Drain connection size, in. [mm] 2 [50] Number of drain outlets Table 2 continues... © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... - Page 11 Average power consumption per cycle, kW-hr 0.25 Average HVAC load, Btu/hr [kcal/hr] 200 [51] Centrifugal Force Data Extract centrifugal force, G’s 208-240 V, 60 Hz 220-240 V, 50 Hz Table 2 © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
- Page 12 Machine Capacity Dimensions [Refer to Figure 3 ] 60 in. [1524 mm] 11.75 in. [298 mm] 18.38 in. [467 mm] 17 in. [432 mm] Table 3 continues... © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
- Page 13 33.47 in. [852 mm] 26.47 in. [675 mm] 34.5 in. [876 mm] 60 in. [1524 mm] 9.75 in. [248 mm] 21 in. [533 mm] Table 4 continues... © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
- Page 14 1.13 in. [29 mm] 3.88 in. [98 mm] 29.5 in. [749 mm] 6.75 in. [171 mm] 6.75 in. [171 mm] 3.88 in. [98 mm] 1.75 in. [44 mm] Table 4 © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
-
Page 15: Installation
To avoid damage to machine, remove inch bolt holes located on the frame at the bottom of each corner. shipping block before operation. One quarter inch machine anchors should be used. © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... -
Page 16: Electrical Installation
WARNING IMPORTANT: Alliance Laundry Systems warranty does not cover components that fail as a result of improper input voltage. Turn off power and water before attempting any... -
Page 17: Drain Connection
National Electric Code ANSI/NFPA No. 70. Overloaded or under- sized lines, or any low voltage condition will burn out motors and solenoid windings. © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... -
Page 18: Water Connection
4 in. [102 mm] 1.25 in. [32 mm] 7 – 10 6 in. [152 mm] 1.5 in. [38 mm] Table 9 1.5 in. [38 mm] Table 10 continues... © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... -
Page 19: Connect Inlet Hoses
Install a screen filter in each hose to keep rust and other foreign particles out of the solenoid valves. Suitable air cushions should be installed in supply lines to pre- vent “hammering” Refer to Figure 8 . © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... -
Page 20: Control Function Test
Close and lock the lid and start a cycle. Attempt to open the lid. If the lid lock and interlock are not functioning properly, call a service technician. © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... - Page 21 6. Check that basket rotation is clockwise in the extract step. If rotation is not clockwise, disconnect power and have a quali- fied electrician reverse lines L1 and L2 at power input block. © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
-
Page 22: Operation
Machine will start automatically after timers are set. The rinse will begin 30 seconds after basket begins to spin. © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... - Page 23 5. Set wash timer for 30 seconds to begin filling tub and allow detergent/bleach to mix. 6. Place washables in compartment. Distribute evenly around agitator. Refer to Figure 13 . CAR24N_SVG 1. Drain Figure 14 © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
- Page 24 W728 NOTE: Place loosely woven washables first, then sheets, pillow slips and other closely woven arti- cles. CAR25N_SVG 1. Drain Figure 16 © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
- Page 25 Operation 11. When cycle is complete, wait until basket stops, then press LID RELEASE button to open lid. Refer to Figure 16 . 12. Remove washables. © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
-
Page 26: Maintenance
© Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT... - Page 27 Locate the pump and tubing below the machine’s injection point to prevent siphoning of chemicals into the machine. © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
- Page 28 For more detailed information about recycling of this product, please contact the local city office, household waste disposal service, or the source from which the product was purchased. MIX1N_SVG Figure 17 © Copyright, Alliance Laundry Systems LLC - F8221501ENR4 DO NOT COPY or TRANSMIT...
Need help?
Do you have a question about the UM202 series and is the answer not in the manual?
Questions and answers