Table of Contents
Advertisement
3.
Be sure the Inside Antenna is NOT
facing toward the Outside Antenna.
This creates potential oscillation
or feedback and reduces the
effectiveness of the DB Pro.
4.
If you do not know how to mount
hardware or run coax cable through
walls, ceilings and floors, get help
from a Wilson Certified Installer
at www.wilsonelectronics.com/wci
or from a qualified contractor or
electrician.
We recommend you install the Lightning
Surge Protector (859992). Attach the
cable from the Outside Omni Antenna to
the surge protector and ground the surge
protector. The LSP is sold separately (refer
to page 11 for more info.
Quick Install
For more detailed instructions on
installation, read the description later
in this guide or watch the video at
wilsonelectronics.com/DBProvideo.
NOTE: Create a "soft" install first by testing
components in your proposed locations
before securing them with hardware.
1.
Select a location on the roof of
the building to install the Outside
Antenna. Make sure the antenna is
clear of obstructions that could block
the signal from the nearest cellular
tower.
2.
Select a location to install the Signal
Booster that is well ventilated and
away from excessive heat, moisture,
and direct sunlight.
3.
Select a location for the Inside
Antenna that is in the center of the
area where the signal needs to
be amplified and a minimum of 20
vertical feet or 50 horizontal feet from
the Outside Antenna.
Inside Panel
Antenna
/}~~
Outside Omni Antenna
'/:/
I
!
DjPro
4.
Run the coax cable from the Outside
Antenna to the Signal Booster and
attach it to the connector labeled
"Outside Antenna." Connect another
coax cable to the connector labeled
"Inside Antenna" and run it to the
Inside Antenna. NOTE: Be careful
not to bend the center pins on
the connectors when securing
connections.
5.
Once you have ensured all
connections are tight, connect the
Signal Booster to a surge protected
power strip with at least a 1000 Joule
rating to protect your equipment from
power surges and lightning strikes
(refer to page 11 for information on
lightning protection).
6.
If your DB Pro is working correctly,
the lights will be green. If the
lights are orange or red, see the
"Troubleshooting" section starting on
page 7.
Outside Antenna Installation
1.
Select a location on the roof or an
outside wall where the Outside
Antenna can be mounted without
obstruction (at least three feet of
clearance in all directions) and with
at least 20 feet of vertical or 50 feet
of horizontal separation from the
Internal Antenna.
2.
After connecting the coax cable to the
antenna, run it underneath the down side
of your roofs flashing if mounted on the
roof. Tip: Often you can follow the route
used by satellite TV cables. If you attach
the Outside Antenna to a wall, run the
cable along the outside of the wall to the
area where you want the cable to appear
on the inside of the building, then drill a
hole through the wall where the cable will
Need help?
~
www.WilsonEiectronics.com
~
D
Tech Support 866-294-1660
5
Mon.- Fri. Hours: 7 am to 6 pm MST
Advertisement
Table of Contents
