Reassembling The Treadmill Fairing - Precor P10 Operating And Maintaining

Installing the Console
4. Line up the two small tabs at the bottom of the console's
5. Insert the two #8–32 × ¹ ₂-inch Phillips-head screws that

Reassembling the Treadmill Fairing

After the console is in place, reattach the two cover panels of
the treadmill fairing.
Important: In the following procedure, do not allow the fasteners
to break or pinch any cables.
To reassemble the fairing:
1.
2. Install one of the access covers over the opening above
3. Secure the access cover with two ¹ ₄-inch × 1-inch
back cover with the slots at the bottom of the console
case. Insert the tabs into the slots.
you removed earlier into the holes at the top edge of the
console's back cover. Tighten the screws fully.
Important: If you are installing a console that is equipped
with a Personal Viewing System (PVS), use caution not to
pinch the cables between the back cover and PVS mounting
screw heads.
Verify that all cables are secure inside the cable ties.
the appropriate upright support. Slide the two tabs under
the edge of the opening as shown in the following figure.
Figure 30: Access panel positioning
buttonhead screws.
51