User Id Entry With Csafe Equipment - Precor P10 Operating And Maintaining

30
Event
Number
81
82
83
85
86
87
88

User ID Entry with CSAFE Equipment

This equipment is fully compatible with CSAFE protocols.
When the equipment is connected to a CSAFE master device,
the user is prompted to press ENTER and begin an
identification process. The user ID is displayed as five zeros
and indicates the starting point. The following table describes
key functions while in CSAFE mode.
Table 5. CSAFE access keys
Keys
Number
Keypad
CLEAR
OK
PAUSE
A message appears on the display and indicates when the
user ID is accepted by the CSAFE master device. Once
program selection is complete, the user can begin exercising.
Description of Event
Phase C missing (incline control; treadmill only)
Phase A or B missing (speed control; treadmill only)
Phase C missing (speed control; treadmill only)
No dynamic break resistor detected, or dynamic break
resistor is detected as an open circuit, at startup time
(treadmill only)
Old console detected on new equipment (treadmill
only)
New console installed on older equipment (treadmill
only)
Motor temperature too high (treadmill only)
Function
Use the number keys to enter a user ID. Once you
have entered the user ID number, press OK to submit
the user ID.
Erases individual numbers in the user ID from right to
left.
Submits the user ID.
Note: User ID entry is bypassed when the user enters
five zeros. No workout statistics are recorded.
Resets to the Welcome banner.
Operating and Maintaining the P10 Console