Chevrolet Cruze Owner's Manual page 70

66 Instruments and controls
Display of remaining engine oil life
%
The remaining engine oil life duration
is displayed in the Driver Information
Center by the control indicator
lowed by a percent value which shows
the remaining engine oil life. For this
purpose the ignition has to be switched
on without engine running.
Driver information Center 72.
Service information 163.
How to reset the engine oil life
system
Reset the system whenever the engine
oil is changed so that the system can
calculate the next engine oil change. To
reset the engine oil life system, depend-
ing on model and country variant, do
one of the following:
Using a scan tool:
n
Your CHEVROLET retailer will
reset the system using this tool after
changing the engine oil.
Using accelerator pedal:
n
◆ Remove key from ignition switch
or with Start/Stop system switch
, fol-
off ignition for more than one
minute.
◆ Insert key in ignition switch and
turn key to position 2 or with
Start/Stop system switch on igni-
tion (ignition on but with engine
off).
◆ Fully press the accelerator pedal
and hold for two seconds.
◆ Release the accelerator pedal for
two seconds.
◆ Repeat pressing and releasing of
the accelerator pedal as described
above two times within one min-
ute.
n Using the SET/CLR button on vehi-
cles with Midlevel-Display:
Press the MENU button on the turn
signal lever to select the Vehicle
Information Menu. Turn the
adjuster wheel until the menu with
the remaining engine oil life dura-
tion is displayed. Press SET/ CLR
button for a few seconds with igni-
tion on. If Code 82 still appears in
the Driver Information Center after
the vehicle has been started, the
engine oil life system has not been
reset. Repeat the procedure.
Using the reset knob on vehicles
n
with Baselevel-Display*: