Chevrolet Cruze Owner's Manual page 100

96 Driving and operating
Open the cover in the bottom of the
cupholder in the centre console. Fold
out the key bit of the electronic key and
insert it into the keyway.
Press the Start/Stop button.
To switch off the engine, press the
Start/Stop button for at least 2 seconds.
Lock the driver's door with the mechan-
ical key. Locking the entire vehicle 23.
This option is intended for emerg-
encies only. Seek the assistance of a
CHEVROLET retailer.
The function (ignition on, lock/unlock
door) of the electronic key may not
work or the operating distance may
change because the frequency is mixed
with close others if any of following
occurs. In this case, open and close the
door using the key manually. If the elec-
tronic key does not work when it is in
the vehicle or you possess it, you can
start the engine by using emergency
operation. If the engine is not running
when you use the key manually, contact
a CHEVROLET retailer.
When the electronic key is close to a
n
radio transmitter such as a radio
station, an airport, a police station, a
government office, a base, a trans-
mitting tower, or a port.
When you keep the electronic key
n
near a mobile two-way radio system
or a cellular phone.
When another vehicle's electronic
n
key is being operated close to your
vehicle.
When the electronic key is dis-
n
charged.
The interior mobile two-way radio sys-
tem can disturb the electrical system of
the vehicle. Use the exterior mobile
two-way radio system. You must
always comply with the specific laws
and regulations of the country that you
are in.
Disabled electronic key
If you lock the door using a electronic
key outside the vehicle when another
electronic key is inside the vehicle, the
inside key will be disabled. It can not
make the engine to start. The disabled
electronic key can be reactivated when
you press the button of the disabled key.
Caution
If the electronic key is very close to
vehicle body like doors, windscreen,
rear window, anyone inside the vehi-
cle may start the engine by pressing
Stop/Start button. Be careful not to
do this.