Chevrolet Cruze Owner's Manual page 108

104 Driving and operating
Control indicator 71.
Switching on
Press rocker switch at the upper end,
control indicator illuminates white.
Activation
Accelerate to the desired speed and turn
thumb wheel to SET/-, the current speed
is stored and maintained. Control indicator
illuminates green. Accelerator pedal can
be released.
Vehicle speed can be increased by
depressing the accelerator pedal.
When the accelerator pedal is released,
the previously stored speed is resumed.
Increase speed
With cruise control active, hold thumb
wheel turned to RES/+ or briefly turn to
RES/+ repeatedly: speed increases
continuously or in small increments.
Alternatively accelerate to the desired
speed and store by turning to RES/+.
Reduce speed
With cruise control active, hold thumb
wheel turned to SET/- or briefly turn to
SET/- repeatedly: speed decreases con-
tinuously or in small increments.
Deactivation
Press button , control indicator
illuminates white. Cruise control is
deactivated. The stored speed is memo-
rised.
Automatic deactivation:
Vehicle speed below approx. 40
n
km/h,
The brake pedal is depressed,
n
n The clutch pedal is depressed for
more than a few seconds,
Selector lever in N,
n
n Engine speed in a very low range.
Resume stored speed
Turn thumb wheel to RES/+ at a speed
above 40 km/h. The stored speed will
be obtained. If the difference between
the current and the stored speed is more
than 40 km/h, the vehicle cannot
resume the stored speed.
Switching off
Press rocker switch at the lower end,
control indicator extinguishes.
The stored speed is deleted.
Switching off the ignition also deletes
the stored speed.