Menu System - Nibe F1245 Installer Manual

Menu system

When the door to the heat pump is opened, the menu
system's four main menus are shown in the display as
well as certain basic information.
Master
Slave
HOT WATER
SERVICE
If the heat pump is set as slave a limited main menu is
displayed because the majority of the settings for the
system are made at the master heat pump.
Menu 1 - INDOOR CLIMATE
Setting and scheduling the indoor climate. See page
38.
Menu 2 - HOT WATER
Setting and scheduling hot water production. See page
46.
This menu is also set in the slave heat pump's limited
menu system.
Menu 3 - INFO
Display of temperature and other operating informa-
tion and access to the alarm log. See page 48.
This menu is also set in the slave heat pump's limited
menu system.
Menu 4 - HEAT PUMP
Setting time, date, language, display, operating mode
etc. See page 49.
NIBE™ F1245
INFO
Menu 5 - SERVICE
Advanced settings. These settings are not available to
the end user. The menu is visible by pressing the Back
button for 7 seconds. See page 54.
This menu is also set in the slave heat pump's limited
menu system.
Symbols in the display
The following symbols can appear in the display during
operation.
Symbol Description
This symbol appears by the information
sign if there is information in menu 3.1
that you should note.
These two symbols indicate whether the
compressor or addition is blocked in
F1245.
These can, for example, be blocked de-
pending on which operating mode is se-
lected in menu 4.2, if blocking is sched-
uled in menu 4.9.5 or if an alarm has oc-
curred that blocks one of them.
Blocking the compressor.
Blocking additional heat.
This symbol appears if lux mode for the
hot water is activated.
This symbol indicates the actual speed of
the fan if the speed has changed from
the normal setting.
Accessory NIBE FLM required.
This symbol indicates whether F1245 has
contact with NIBE Uplink™.
This symbol indicates whether "holiday
setting" is activated in menu 4.7.
Chapter 7 | Control - Introduction 35