Nibe F1245 Installer Manual page 68

Remove the connections from the base card (AA2)
5
using a screwdriver.
Disconnect the connectors (A) and (B) from the
6
underside of the base card cabinet.
Disconnect the connector (C) from the immersion
7
heater circuit board (AA1) using a screwdriver.
Disconnect the connector (D) from the joint circuit
8
board (AA100).
Carefully pull out the cooling module.
9
TIP
The cooling module is installed in reverse or-
der.
66 Chapter 9 | Service
5
8
6
D
A
B
9
7
C
NOTE
At reinstallation, the supplied O-rings must
replace the existing ones at the connections
to the heat pump (see image).
QM33
F1245
QM34 QM32
NIBE™ F1245