Carburetor Removal And Installation - Ford VSG-411 Service Manual

3-18
Fuel System
3-18
REMOVAL AND INSTALLATION
CARBURETOR
Removal
1. Remove the air cleaner.
2. Disconnect the fuel inlet line, distributor vacuum hose and
anti-dieseling solenoid wire (Figure 24).
3. Disconnect the carburetor throttle linkage. Disconnect choke
cable.
4.
Remove carburetor retaining nuts and lift off carburetor.
5. Remove and discard carburetor gasket.
Installation
I. Install new carburetor gasket and mount carburetor. Secure
with retaining nuts.
2. Connect throttle linkage and the choke cable. Check operation
of throttle and choke for full travel.
3. Connect fuel line, distributor vacuum line and anti-dieseling
solenoid wire.
4.
Install air cleaner. Be sure vacuum and crankcase ventilation
hoses are connected.
"
5. Start engine and operate at a fast idle speed until normal
operating temperature is reached.
6. Adjust idle fuel mixture and idle speed.
FIG. 24 Items to be Disconnected for Manual Choke Carburetor Removal (Carburetor Retaining Nuts Arrowed)
A -
Fuel Supply Hose
D - Throttle Linkage
B - Choke Cable Connections E - Anti-Dieseling Solenoid Wire
C - Vacuum Hose