Oil Filter And Adapter; Oil Pressure Sender; Engine Front Cover; Sensors - Ford LRG-423 Service Manual

02-40
Engine Service, 2.3L
02-40
2.3L ENGINE SERVICE (Continued)
Oil Filter and Adapter
Removal
1. Position oil drain pan under oil filter.
2. Using suitable oil filter wrench, loosen oil filter.
3. Unscrew oil filter by hand and remove. Properly
recycle or dispose of oil in filter.
Installation
1. Apply clean motor oil, of the same type as is
being used in the engine, to the oil filter gasket.
2. NOTE: Do not tighten filter with oil filter wrench.
Install oil filter and tighten by hand.
INSERT
6890
/
TIGHTEN TO
28-35
Nom
CYLINDER BLOCK
/
6010
w 6714
LIGHTLY OIL GASKET
AND HAND TIGHTEN
A24005-A
SPECIAL SERVICE TOOL(S) REQUIRED
Sensors
Oil Pressure Sender
Removal and Installation
NOTE: The pressure switch-type sender used with the
indicator lamp system is not interchangeable with the
variable resistance-type unit which is used with the
gauge system. Refer to the Master Parts Catalog for
proper parts usage. Installation of the wrong part will
result in an inoperative oil pressure indicating system
and a damaged sender unit or gauge.
1. Make sure the ignition switch is turned off.
2. Disconnect the wire at the sender terminal.
3. Remove the oil pressure sender (9278) from the
cylinder head (6049).
4. Apply Pipe Sealant with Teflon@ D8AZ-19554-A,
or equivalent, meeting Ford specification
WSK-M2G350-A2 to new sender threads.
For installation, follow removal procedures in reverse
order. Tighten switch to 11-24 Nom (8-l 8 lb-ft).
0
A
PPDA24007-A
Item
1
2
3
4
A
Part
Number
6049
6010
9278
-
-
Description
Cylinder Head
Cylinder Block
Oil Pressure Sender
Coolant Temperature Sender
Tighten to 11-14 Nom (8-18
I b-ft)
Engine Front Cover
Description
I
Tool Number
I
Holding/Removing Tool
T74P-6256-B
Front Cover Seal Remover
T74P-6700-B
Front Cover Alignment Tool
T74P-6019-B
Front Seal Replacer
T74P-6150-A
NOTE: This procedure will require the following
replacement parts: oil pan gasket (6710), crankshaft
front seal (6700), engine front cover gasket (6020) and
a water pump inlet tube O-ring (87056-5100).