Yamaha YZF-R1S Service Manual page 206

HANDLEBARS
2. Install:
S right handlebar switch 1
NOTE:
Align the projection a on the right handlebar
switch with the hole b in the right handlebar.
3. Install:
S brake master cylinder holder 1
CAUTION:
S Install the brake master cylinder holder
with the "UP" mark facing up.
S First, tighten the upper bolt, then the lower
bolt.
NOTE:
S Align the mating surfaces of the brake master
cylinder holder with the punch mark a in the
right handlebar.
S There should be 2 mm (0.08 in) of clearance
between the right handlebar switch and the
brake master cylinder holder.
4. Install:
S throttle grip
S throttle cable housing 1
S throttle cables
NOTE:
Align the projection a on the throttle cable
housing with the hole b in the right handlebar.
5. Install:
S clutch lever holder 1
NOTE:
Align the slit in the clutch lever holder with the
punch mark a in the left handlebar.
4-59
CHAS