Removing The Swingarm - Yamaha YZF-R1S Service Manual

SWINGARM AND DRIVE CHAIN
EAS00703

REMOVING THE SWINGARM

1. Stand the motorcycle on a level surface.
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
Place the motorcycle on a suitable stand so that
the rear wheel is elevated.
2. Remove:
S relay arm-to-swingarm bolt 1
S connecting arm bolt 2
S rear shock absorber assembly lower bolt 3
NOTE:
When removing the rear shock absorber as-
sembly lower bolt, hold the swingarm so that it
does not drop down.
3. Measure:
S swingarm side play
S swingarm vertical movement
a. Measure the tightening torque of the pivot
shaft nut.
b. Measure the swingarm side play A by mov-
ing the swingarm from side to side.
c. If the swingarm side play is out of specifica-
tion, check the spacers, bearings, washers,
and dust covers.
d. Check the swingarm vertical movement B
by moving the swingarm up and down.
If swingarm vertical movement is not smooth
or if there is binding, check the spacers,
bearings, washers, and dust covers.
4-71
CHAS
Pivot shaft nut
105 Nm (10.5 mSkg, 76 ftSlb)
Swingarm side play
(at the end of the swingarm)
1.0 mm (0.04 in)