Checking The Coolant Level - Yamaha YZF-R1S Service Manual

ADJUSTING THE EXUP CABLES/

CHECKING THE COOLANT LEVEL

7. Install:
S bottom cowlings
EAS00102
CHECKING THE COOLANT LEVEL
1. Stand the motorcycle on a level surface.
NOTE:
S Place the motorcycle on a suitable stand.
S Make sure the motorcycle is upright.
2. Check:
S coolant level
CAUTION:
S Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant check, and if nec-
essary, correct the antifreeze concentra-
tion of the coolant.
S Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
3. Start the engine, warm it up for several min-
4. Check:
S coolant level
NOTE:
Before checking the coolant level, wait a few
minutes until it settles.
3-37
Refer to "COWLINGS".
The coolant level should be between the
maximum level mark a and minimum level
mark b .
Below the minimum level mark ! Add the
recommended coolant to the proper level.
utes, and then turn it off.
CHK
ADJ